Terberg OMNIDEKA e - Page 30

30 EN
EN
3. Bin lift operation
37878
05-2017
ã Terberg Machines B.V., IJsselstein, The Netherlands
All rights reserved. No part of this book may be reproduced, stored in database or retrieval system, or published, in any form or in any way,
electronically, mechanically, by print, photoprint, microfilm or any other means without prior written permission from the publisher.
3.11.5 Diagnostic System - Settings
N6 comb sensor / setting time delay, 2-Wheel bins / up and down speed
SETTINGS
SETTINGS: SPEED SETTINGS SETTINGS: LIFTER SPEED: UP SPEED 2W: 100% UP SPEED 2W: - - - % UP SPEED 2W: - - - % UP SPEED 2W: - - - % MONITOR
push 3x
confirm withchange with confirm withchange with confirm withchange with
LIFTER SPEED: UP SPEED 2W: 100%
2-wheel bins UP- and DOWN SPEED
push 8x
0 % 0 0 % 0 0 0 %
LIFTER SPEED: DOWN SPEED 2W: 100% DOWN SPEED 2W: - - - % DOWN SPEED 2W: - - - % DOWN SPEED 2W: - - - %
confirm withchange with confirm withchange with confirm withchange with
LIFTER SPEED:
DOWN SPEED 2W: 100%
0 %
0 0 % 0 0 0 %
When exceeding the max. or min. value
the most recently set value appears.
Max. value = 100 % Min. value = 50 %
SETTINGS: N6 SENSOR TIMER SETTINGS: MOVE DOWN TIME AFTER N6 OFF: 0.0 SEC MOVE DOWN TIME AFTER MOVE DOWN TIME AFTER MOVE DOWN TIME AFTER MONITOR
push 3x
confirm withchange with confirm withchange with confirm withchange with
MOVE DOWN TIME AFTER N6 OFF: 0.0 SEC
N6 comb sensor SETTING TIME DELAY
push 7x
N6 OFF: 0 SEC N6 OFF: 0 0 SEC N6 OFF: 0 0. 0 SEC
When exceeding the max. or min. value the following message appears:
Enter value 999 for factory settings.
! VALUE OUT RANGE !