7 MAINTENANCE
91
7.20 Chassis/Engine Cleaning
Periodic cleaning of the chassis area beneath the cab and engine compartment is
also necessary to maintain safe operation. Clean as necessary. (fig. 7.20-1)
To clean the chassis/engine:
1. Shut the machine down as described in section 5.13, allow the machine to
cool thoroughly, then lower the belly pans on the underside of the machine.
2. Raise the hood and lower the side panels at the rear of the machine.
3. Pressure wash any debris from the engine compartment out through the
lower opening.
4. Tilt the cab as described in section 7.23.
5. Pressure wash any debris from the chassis area out through the lower
opening. Once complete, lower and secure the cab.
6. Re-secure the belly pans, then close and secure the hood and side panels
to complete the cleaning procedure.
Coolant and machine components can be HOT! Allow the machine to
cool thoroughly prior to performing maintenance or service to avoid the
possibility of burns.
If any safety signs are found to be damaged or missing after cleaning,
contact your dealer for a replacement immediately. They can be reap-
plied according to the location illustration in section 2.3 of this manual.
PT-110/PT-110F US O&M
2095-479 2013-02
7.20-1
7.19-1
2
To Next Page
