5 OPERATION
55
5.12 Operation on Inclines
Skid steer loaders are designed to be stable on small inclines. However, it wise to
use caution while operating on inclines to minimize any possible hazards.
5.13 Shut Down Procedure
1. Stop, lower and disconnect any work attachments that may be coupled to
the quick attach.
2. Park the machine in a safe location (on firm and level ground) where it is
protected from the elements and vandals.
3. Lower the lift arms until they rest on the frame stops.
4. Reduce engine RPM to a low idle.
5. Turn the ignition key to the off position to stop the engine.
6. Remove the safety belt and raise the lap bar (if equipped).
7. Open the door (if equipped) and exit the machine using 3 points of contact
as described in the starting procedure in this section.
Caution should always be exercised while operating the machine on an
incline. Avoid operation on steep inclines. Do not make sudden changes
in direction, move slowly, and always carry loads low to maximize machine
stability.
To Next Page
Loading...
Need help?
General
