Page 41/62
Rev. A
2017-12-04
SCANTER 1002 Radar System
User’s Manual
1255194-HO
The “Site Default” create option copies the” Transceiver configuration” to the “Site
Default” area. Restore copies the “Site Default” to the “transceiver configuration”
area. The transceiver will restart to activate and use the new data.
The “Factory Default” data contains basic parameter values for the transceiver.
These are created at transceiver production and should not be used after the radar
has been set up.
Restoring the “Factory Default” data will delete the “transceiver configura-
tion” area. The transceiver will then be out of service, unless a backup has
been created on the RST that can be restored.
To Next Page
Loading...
