Wall Connector Internal Components
1. RS-485 port
2. Contact blades
3. Temperature sensor
4. Conductor terminals
5. Zip tie anchor
6. Sliding contacts
7. Wirebox drainage opening (enables Type 3R protection)
PRODUCT OVERVIEW
15Gen 3 Wall Connector Manual
INSTALLATION
In the Box
Main Unit
Wirebox
Wirebox Mounting
Template
Hex Bit (4 mm)
Zip tie (x1)
Wall Connector-to-
Wirebox Fastener
(x4)
Wirebox-to-Wall Fastener
(x2)
Quickstart Guide (contains
sticker with SSID network name
and unique passw
ord)
SAVE THIS DOCUMENT
NOTE: The hex bit, zip tie, and fasteners are located in a plastic bag inside the wirebox, which comes
a
ttached to the main unit of the Wall Connector.
NOTE: Wall plugs are not included. If installing in concrete or other like materials, use 6 mm wall
plugs.
To Next Page
Loading...
