Grounding Connections
Wall Connector must have a ground path back to the main equipment earthing point on site. Without a
proper ground connection, the Wall Connector will fault during a ground assurance test. Equipment-
grounding conductor must be run with the circuit conductors and connected to the equipment-grounding
terminal in the wirebox. Install a ground (PE) wire sized according to local electrical code.
PRODUCT OVERVIEW
7Gen 3 Wall Connector Manual
Using Wall Connector
1. Open the vehicle charge port by pressing the button on the charge handle, pressing on the charge
port door, using the mobile app, using the vehicle touchscreen, or by pressing and holding the trunk
button on the keyfob.
2. Insert the charge handle into the vehicle charge port.
3. Check the vehicle controls to verify charging.
4. To remove the charge handle from the vehicle, press and hold the button on the handle to unlock the
charge port.
NOTE: The vehicle must be unlocked for the charge handle to be removable.
5. Remove the charge handle from the vehicle charge port.
6. Wrap the charge cable counter-clockwise around the Wall Connector and insert the charge handle into
the holster.
To Next Page
Loading...
