Step 5: Strip and Land Wiring
1. Strip insulation from wires ~1/2 in (~13 mm), route through service channel, and land each wire in its
correct terminal block.
NOTE: Terminals are bi-directional.
2. Secure the wiring in the service channel using the included zip tie.
3. Use a torque driver and the included 4 mm hex bit to torque the terminal screws to 50 lbf . in (5.6
Nm).
NOTE: When installing Wall Connector in a split phase electrical system, use Line-to-Line
instead of Line-to-Neutral.
INSTALLATION
25Gen 3 Wall Connector Manual
To Next Page
Loading...
