Step 3: Prepare Wirebox and Mount to Wall
1. Use a 1/4 in (6.5 mm) bit to drill two pilot holes into the wirebox that match the locations chosen on
the cardboard mounting template.
Drill bit, 1/4 in (6.5 mm)
Top Entry Bottom Entry Bottom Left Entry Bottom Right Entry
2. Attach the wirebox to the mounting location using the included 4 mm hex bit and the two included
wood fastener screws.
NOTE: Type 3R rating is only possible when washers have sealing gaskets. If mounting to
alternate surface (such as a prefabricated pedestal), use alternate fasteners with sealing
washers.
NOTE: The wood fastener screws are designed to support the weight of the entire Wall
Connector, cable, and charging handle.
INSTALLATION
23Gen 3 Wall Connector Manual
To Next Page
Loading...
