6 Using the product
41
The testo 380 has 3 test types:
• the Compliance measurement test is for official
measurements in accordance with the 1st BImSchV
• the Adjustment help test is for the adjustment of combustion
processes
• Approval test is for individual room furnaces
> The operating status of the combustion system to be measured
must comply with the national directives.
Options
> Operation check: an operation check of the measurement
system can be carried out, .
> Tightness test: the tightness of the fresh air and gas path is
tested.
> Particle analyzer info: testo 380 information is displayed.
> Probe info: information on the particulate matter probe is
displayed.
> Nozzle data: select and edit nozzle calibration data.
> Particle sensor pump: on or Particle sensor pump: off: the
sensor pump is switched on or off.
> [Options] → Test Bed (gradient check) (only for test beds
and testo Service): procedure for checking the determinant
measurement parameters for the six-monthly inspection of the
test bed with specialised equipment.
> [Options] → Diagnosis (service): only for Testo Service.
Measuring
1. Select compliance measurement, adjustment help or approval
test: [▼] → [OK].
- System check: tightness test successfully completed?
> [Yes]: continue with point 2.
> [No]: Carry out tightness test.
2. Select solid fuel: [▲], [▼] → [OK].
To Next Page
Loading...
