Teuco 620 - Filling the Sand Filter

33
EN
620
4. 
Fill the pool until the water is up to
the rim.
5. 
a - Remove the cap of the sand lter
by undoing the nuts and washers.
b - Place a bag over the pipe inside
the lter, for protection.
c - Pour 45 litres of water into the
container and, slowly, add 6 bags
of sand (supplied with the pool),
making certain not to damage the
inside of the lter.
CAUTION: DO NOT INHALE THE
DUST.
Having completed the above steps,
remove the protective bag and
clean the rim of the lter.
Ret the cap of the lter, greasing
the seal with vaseline.
Tighten the nuts and washers
uniformly, 
6.
Continue lling the pool, allowing
the water to spill over the edge and
away to the overow tank.
     
     

7.
Open all valves along the pipelines,
except for the system drain valve,
and check that there are no leaks
from pipes or ttings.
45 lt.
x6
a a
 
 