Teuco 620 - Page 34

34
EN
620
8. 
Set the lter pump switch to “STOP”.
Power up the control panel by setting the main
switch to “ON”.
The ller solenoid valve will cut in automatically to
bring the water up to operating level in the overow
tank.
Set the lter selector valve to “3” (RINSE).
Set the pump switch to “MAN” (manual).
Water will now ow from the overow tank into the
lter, washing the sand, and from the lter directly
to the drain.
After 30-40 seconds operation, shut off the rinse
ow by setting the pump switch to “STOP”.
9.
Shift the selector lever to position “1” (FILTER) .
Set the pump switch to “MAN” (manual).
Water will begin owing from the pool through the
lter.