Texas Instruments CC2540 - Release Notes History; BLE Library: Add to LIB Group

Release Notes History www.ti.com
90
SWRU271H–October 2010–Revised April 2019
Submit Documentation Feedback
Copyright © 2010–2019, Texas Instruments Incorporated
General Information
6. Add the CC2540_BLE_peri.lib to the library group.
Figure 9-6. BLE Library: Add To LIB Group
7. You also have to ensure to exclude the CC2540 library from the other CC2541 configurations.
9.4 Release Notes History
Texas Instruments, Inc.
CC2540/41 Bluetooth® Low Energy Software Development Kit
Version 1.4.2 June 7, 2016
Notices:
• This version of the Texas Instruments BLE-Stack and software is a maintenance update to the v1.4.1
release and contains several bug fixes
• For applications running v1.4.1 or later, no application porting is required since all changes are in
protocol stack libraries.
• TI recommends using BLE-Stack v1.4.1 or later to ensure pairing compatibility with Android 6.0
(Marshmallow) devices
• The included Software Developer's Guide (SWRU271G) is compatible with this release
• All projects have been migrated to IAR Embedded Workbench for 8051 v9.10.3
Bug Fixes:
• Fixed an issue where Limited Discoverable advertising doesn't end if the ADV payload length is 31
bytes
• Fixed an issue where the GATT Client is not able to read the full GAP Device Name when the name
length is > 19 characters.
• Added check for GATT_PERMIT_ENCRYPT_WRITE in ggs_SetAttrWPermit
• Addressed Central role stability issueswith multiple connections when performing concurrent
operations: pairing, scan or initiating.
• Fixed an issue with Channel Map Updates not properly ack'd in certain conditions when Slave Latency
is applied
• Fixed a condition where Slave Latency was not temporarily disabled in degraded RF channel
conditions
• Fixed a slave condition where LL_TERMINATE_IND is not ack'd if sent at the 6th interval after
receiving a LL_CONNECTION_UPDATE_IND