Start-up in main()
www.ti.com
22
SWRU271H–October 2010–Revised April 2019
Submit Documentation Feedback
Copyright © 2010–2019, Texas Instruments Incorporated
The Application and Profiles
4.3 Start-up in main()
The main() function in SimpleBLEPeripheral_Main.c is the starting point at runtime. This function brings up
the board and initializes the OSAL and SNV drivers. Next, this function initializes power management and
creates the tasks. Finally, the function calls the osal_start_system(), which starts the processing loop
(OSAL) and does not return.
To Next Page
Loading...
