www.ti.com
Project Overview
21
SWRU271H–October 2010–Revised April 2019
Submit Documentation Feedback
Copyright © 2010–2019, Texas Instruments Incorporated
The Application and Profiles
The file list is divided into the following groups:
• APP – These are the application source code and header files. More information on these files can be
found later in this section.
• HAL – This group contains the HAL source code and header files. For more information on the HAL
group, see Chapter 6.
• INCLUDE – This group includes all of the necessary header files for the Bluetooth Low Energy protocol
stack API. For details, see Appendix A through Appendix G and CC2540 Bluetooth low energy API
Guide.
• LIB – This group contains the protocol stack library file CC2540_BLE_peri.lib. For more information on
the protocol stack libraries, see Section 5.8.
• NPI – Network processor interface, a transport layer that allows you to route HCI data to a serial
interface. CC254X_BLE_HCI_TL_Full.lib must be included for this capability (see the HostTest project
in the SDK). If not used, the CC254X_BLE_HCI_TL_None.lib should be used (see
SimpleBLEPeripheral in the SDK) when developing a single-chip application).
• OSAL – This group contains the OSAL source code and header files. For more information on the
OSAL, see OSAL API Guide and Chapter 3.
• PROFILES – This group contains the source code and header files for the GAP role profile, GAP
security profile, and the sample GATT profile. In addition, this section contains the necessary header
files for the GATT server application. For more information on these modules, see Chapter 5.
• TOOLS – This group contains the configuration files buildComponents.cfg and buildConfig.cfg.
Section 5.8 describes these files and contains the files OnBoard.c and OnBoard.h, which handle
interface functions.
• OUTPUT – This group contains files that are generated by IAR during the build process, including
binaries and the map file, see Section 8.3.4.
To Next Page
Loading...
Need help?
General
