• An indentation on each side of the TI Charging Station CE enables you to
lift it. Always use two hands to lift and move the charging station.
• When the charging station is empty, turn it over and you will notice and
indention on the bottom. Thread the cable through this indention to ensure
the charging station sits flat on a surface.
• Place the charging station on a flat, stable surface. You can also use a
wheeled cart if you need to move the charging station between
classrooms. When deciding on a location, consider its proximity to a power
source such as a power strip or wall outlet.
Inserting Graphing Calculators into the TI Charging Station CE
The slots in the TI Charging Station CE are designed to accommodate a
graphing calculator without a slide case attached. The calculator will not fit in
the slots with the slide case attached.
The front of the calculator must face the front of the charging station. You may
damage the TI-84PlusCE graphing calculator if you try to force it into the
charging station facing the wrong direction. When looking at the TI logo on the
charging station, insert calculators into the slot with the keypad facing left.
Using Accessories 57
To Next Page
Loading...
Need help?
General
