EasyManua.ls Logo

Texecom PREMIER 168 - Page 107

Texecom PREMIER 168
112 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Premier 48, 88, 168 & 640 Installation Manual Quick Reference Guide
INS176 107
Key Output Group Outputs Types
Not Used: Press
to accept
System:
Use
-
to enter an output type or use
to search,
to accept
00: ATS Path Fault 18: UDL Lockout
35: Custom 4 Stage A
01: Mains Power Off 19: UDL Call Active
36: Custom 4 Stage B
02: Aux Fuse Fault 20: UDL Enabled 37: Custom 4 Stage AB
03: Auxiliary Tamper 21: Confirmed Alarm 38: Com 1 Fault
04: Bell Tamper 22: Custom 1 Stage A 39: Com 2 Fault
05: Panel Lid Tamper 23: Custom 1 Stage B 40: Com 1 No Signal
06: Engineer Working 24: Custom 1 Stage AB 41:
Com 2 No Signal
07: Confirm Devices 25: Custom 2 Stage A 42: Coms Fault
08: Service Required 26: Custom 2 Stage B 43: Radio Jamming
09: Bell Fuse Blown 27: Custom 2 Stage AB 46:
Radio RX Tamper
10: Battery Fault
28: Radio-Pad Failed 47: Detector Test
11: Battery Test On
30: No Radio Signal 48: ATS Remote Test
12: Courtesy Light
31: Radio-Pad Lost 49: No ATS Available
13: System Open
30: No Radio Signal 50: CIE Fault
14: Fully Arm
31: Radio-Pad Lost 51: PSU Fuse Blown
15: Digi Failed
32: Custom 3 Stage A 52: PSU Battery Flt
16: Digi Successful
33: Custom 3 Stage B
17: Digi Active
34: Custom 3 Stage AB
Area: Use
-
to enter an output type or use
to search,
-
to select an area,
(
= all areas,
= areas A – H and I –P),
to accept
00: Intruder Alarm 23: Part Armed 46: Time Arming
01: Guard 1 Alarm 24: Part Arming 47: 1
st
Code Entered
02: Guard 2 Alarm 25: Force Arm 48: 2
nd
Code Entered
03: Entry Alarm 26: Force Arming 49: Area Secured
04: Confirmed Alarm 27: Arm Fail 50: Part Armed 1
05: 24Hr Audible 28: Bell SAB 51: Part Armed 2
06: 24Hr Silent 29: Bell SCB 52: Part Armed 3
07: 24Hr Gas 30: Strobe 53: Custom Alarm
08: PA Audible 31: Switch 12 Volts 54: Zone Warning
09: PA Silent 32: Detector Reset 55: Arm Fail Warning
10: Duress 33: Walk Test Active 56: Forced Entry
11: Fire Alarm 34: Zones Omitted 57: Zones Locked Out
12: Medical 35: 24Hr Zones Omit 58: All Armed
13: Auxiliary Alarm 36: Reset Required 59: Auto Arm Disable
14: Tamper Alarm 37: Door Strike 60: Armed / Alarm
15: Alarm Abort 38: Chime Mimic 61: Intruder Alarm
16: Ready 39: Chime Enabled 62: Speaker Mimic
17: Entry Mode 40: DK First Knock 63: Full Arm/Exit
18: 2
nd
Entry Mode 41: BP First Knock 64: Detector Fault
19: Exit Mode 42: On Test 65: Detector Mask
20: Entry/Exit Mode 43: Test Fail 66: Fault Present
21: Armed 44: Internal Alarm 67: LED Control
22: Full Arm 45: Auto Arming 68: Full Arm Entry
Zone: Use
-
to enter a zone number or use
to search,
-
to select a zone
output type,
to accept
Mimic
Alarm
MimicLatch
MimicArm
Tamper
Omitted
User: Use
-
to select a User code or use
to search,
to accept
Control Timer: Use
-
to select a Control Timer,
to accept
PC Control: Use
-
to select a PC Control,
to accept
Door Control: Use
-
to select a Door Control,
to accept
X-10: Use
-
to select a an X-10 Output,
to accept

Table of Contents

Other manuals for Texecom PREMIER 168

Related product manuals