System Program Menus Premier 8SP Master User Manual
16 INS237
User Options !$
User Options can be enabled or disabled for a selected user
so that the level of access to the system may be altered. The
following options are available:
#, Allow Arming
On: The user can arm the system.
Off: The user cannot arm the system.
$, Allow Bypassing
On: The user can bypass zones.
Off: The user cannot bypass zones.
%, Allow Disarming
On: The user can disarm the system.
Off: The user cannot disarm system.
"
The Engineer code (User 00) can only disarm the
system, if the system was armed with the Engineer
code.
(, Enable Open/Close Reporting
On: The system will report an Open/Close condition to the
alarm receiving centre when the Access code is used
to disarm or arm the system.
Off: The system will not report an Open/Close status.
"
The panel will always send an Open signal after an
alarm even if this option is disabled.
User Text (LCD Only) !%
If the system is fitted with a LCD remote keypad you can
assign up to 8 characters of text to each user. This text is
used when viewing the system Event Log, see page 12.
User text is programmed in a similar way to mobile phones.
Characters are selected by pressing the corresponding key
the appropriate number of times (to select a character on
the same key, press 6 to move the cursor along). For
details on entering text, see page 13.
Program Manager Users !&
This menu option allows you to add “Manager” users to the
system. The user will automatically be assigned the
“Manager” type and have all “User Options” enabled.
To Next Page
Loading...
