INS303-5 14/22
Installation
Remove all power from module panel before making any connections.
Install the External Prox in the required location.1.
Ensure that Options switch 1 is set to ON (Internal Prox. Enabled) and2.
switches 2, 3 and 4 are set as required,(see chapter 3.1)
Set the Internal/External coil jumper links 14 to External (Ext).3.
6.0 Stand-alone Mode Installation
6.1 Introduction
When the iProx is used in the Stand-alone mode, it allows the unit to be used as a
simple single door access controller. The module can learn and store up to 10
proximity tags, which can be either the Premier Elite proximity tags or 3rd party
proximity tags or cards via the 26bit Wiegand .
6.2 Option Switches for Network Mode
Option Switch For Network Mode
When installed in this mode the Options and Address switches function as follows:
To Next Page
Loading...
