INS303-5 9/22
Learning Premier Elite Proximity Tags
If the system is already using Premier proximity tags then the existing tags will
work as normal when presented to the iProx module. For full details on learning
proximity tags refer to the control panel installation manual.
3.4 Using 3rd Party Proximity Tags
This configuration allows you to use proximity tags from other manufacturers. The
proximity reader MUST be capable of providing the data in 26bit Wiegand format.
The figure below shows a typical installation:
Installation
Remove all power from control panel before making any connections.
Install the 26bit Wiegand reader in the required location and according to the1.
manufacturer’s instructions.
Install the iProx module at least 0.5 metre away from the 26bit Wiegand2.
reader and from other metal objects and cables.
Connect the network connections of the module to the network connections3.
of the control panel.
Connect 26bit Wiegand reader to the iProx as shown above.4.
Connect the optional devices such the door strike, RTE button and speaker.5.
Ensure that Options switch 1 is set to OFF (Internal Prox. Disabled) and6.
switches 2, 3 and 4 are set as required, (see chapter 3.1)
To Next Page
Loading...
