INS884EN-4 15/87
the SmartCom 4G must be power cycled to enable the modem.
Note: See Section 10 FAQ’s & Troubleshooting.
6.2 Removal from mounting tamper
The removal from mounting tamper should be used for all installations. Ensure a
suitable sized screw and fixing is used for the substrate where the device is
mounted. Forced removal of the device from the mounting surface will cause the
plastic to be break and cause a tamper condition.
Note: The plastic housings rear tamper breakout is sacrificial and cannot be
reinstated.
To Next Page
Loading...
Need help?
General
