INS884EN-4 4/87
1.0 Introduction
The Texecom SmartCom 4G creates a new generation of simple connectivity for
customers. With the emergence of cloud technologies Texecom has introduced the
SmartCom to take the Premier Elite product line into the future and enable
customers to transition their systems. Texecom are now offering the SmartCom 4G
in addition to the existing SmartCom product.
The SmartCom 4G comes with an in-built world roaming eSIM and there is no
configuration required. Simply connect to the Texecom Cloud by generating an
App code and you can choose between either Single Path 4G or Dual Path with the
IP path as the primary and 4G as the back-up.
The SmartCom 4G supports the Texecom Cloud service and the Texecom Connect
app.
Texecom Monitor
Texecom Monitor enables communication to selected ARC's to provide alarm
signalling based on the requirements of EN50131-1, EN50136-2 and EN50131-10.
Care should be taken when installing systems using Texecom Monitor to ensure
the following requirements are met.
Wi-Fi is not permitted1.
Ethernet connections must use screened cable2.
The antenna lead must be less than 3mtrs long3.
CIE congfiguration should be left at factory settings for Grade 2 or Grade 3. 4.
2.0 SmartCom 4G
The SmartCom 4G is compatible with all Premier Elite panels including Premier
Elite 640, it does require V5.04 firmware or above. It is supplied as a separate
module that is connected to two COM Ports within the panel. For those familiar
with fitting the SmartCom product the SmartCom 4G follows exactly the same
process.
To Next Page
Loading...
Need help?
General
