INS884EN-4 5/87
Key Features
Ethernet and WiFi
GSM - 4G connection (also connects to 2G and 3G networks, when no 4G is
available)
In built eSIM - for security
Private secure APN connection
Enables Texecom Connect (V2) and Texecom Cloud Service
Easy integration with Premier Elite V5.04 firmware
Compatible with future cloud systems management
Simple user web page for WiFi configuration
Secure - no need to open firewalls for port forwarding
3.0 Future Support
At launch SmartCom 4G will not provide alarm signalling services. SmartCom 4G
has been designed to enable it to be used to provide dual path EN50136 graded
communicators for secure alarm transmission. This will provide connection direct
to ARC’s as primary signalling services. This solution is branded Texecom Monitor
and will be released later this year. At that point your SmartCom 4G will be
firmware upgradeable to support this service.
4.0 Requirements - System
To setup a Texecom Cloud connection or Texecom Connect system you will need
the following as a bare minimum:
A Texecom Premier Elite security system with V5.04 or later firmware
installed
SSID & Password for the Network if you intend to connect by WiFi
A Texecom SmartCom 4G (also with Ethernet & WiFi)
A Texecom Cloud Installers account
Texecom Connect V2 App for iOS or Android (to use the Texecom Connect
service)
When attaching the system to the cloud you will be offered alternative
To Next Page
Loading...
Need help?
General
