Texi Integra 5 - Change Feed Dog Settings

EN
NOTE: TURN OFF THE POWER.
CHANGE FEED DOG SETTINGS
Standard hem stitching,
set change feed dog in “S”
position.
When change feed dog
is in the “S” position,
the tongue “A” is in this
position. This setting can
be used for all standard
hem stitching.
When change feed dog is in the “R” position, the
tongue “A” is in this position. This setting can be used
for all curl hem stitching.
Remove cloth waste box, turn
trimming width adjustment
knob (adjust range between 3.0-
4.5mm).
The width of the
adjustment is
marked on the
Needle plate,
“R” indicates the
trimming width at
curl hem stitching.
Note: If the
looper cover
is opened, it is easier to adjust the trimming
width.
Curl hem stitching & cover
stitch sewing, set change
feed dog in “R” position.
Texi Integra 5 103