Texi Integra 5 - 2-Thread Crimped Overlock; Machine Maintenance

EN
2-THREAD CRIMPED OVERLOCK
CLEANING THE MACHINE OILING THE
MACHINE
CLEANING RUBBER BASE
MACHINE MAINTENANCE
Remove the cloth waste cover,
open the looper cover, put the
upper knife in the non working
position, remove the presser
foot, clean the , the upper k
Needle plate nife, the lower
knife and the looper area with
the brush in the accessory box.
Lubricate the
machine according
to the picture after
cleaning.
Periodically clean the sucker
with alcohol to ensure the
stability of the machine.
If the lower looper thread (purple) is too loose. Adjust
the right needle tension knob (blue) to lower value or
adjust the lower looper thread tension knob (purple) to
higher value.
If the lower looper thread (purple) is too tight. Adjust
the right needle thread tension knob (blue) to higher
value or adjust the lower looper tension knob (purple)
to lower value.
NOTE: Turn o the power before operation.
Note: Use the 2-thread spreader to help sewing
YELLOW BLUE GREEN PURPLE RED
N N
Texi Integra 5 119