EN
COVER STITCH AND 2-THREAD CHAIN STITCH SEWING
Sew coverstitch :
1. The hand wheel rotates along the direction of the arrow until the needle rose to
its highest position. Unload standard presser foot. Remove the cloth waste box,
open the looper cover, separate the upper knife, transfer change feed dog to “R”.
2. Lift the presser foot. With the Multi-function screwdriver in the accessory box
unscrew Needle plate screws A, B. Remove Needle plate.
3. Install the cover stitch Needle plate in the accessory box, Tighten the screws A,
B again. Replace on the cover stitch needle D and 2-thread chain stitch needle C
and the. cover stitch presser foot.
Sew 2-threads chain stitch:
1. The hand wheel rotates along the direction of the arrow
until the needle rose to its highest position. Mount
2-thread chain stitch needle C. Remove the cloth waste
box, open the looper cover, separate the upper knife,
transfer change feed dog to “S”.
2. The hand wheel rotates along the direction of the arrow
until upper looper reaches the lowest place.
3. With the screwdriver (L) in the accessory box unscrew
upper looper screw (at 19). Separate
upper looper and upper knife. The
2-chain stitch looper threading,
then the needle threading.
NOTE: TURN OFF THE POWER.
Texi Integra 5 107
To Next Page
Loading...
