Texi Integra 5 - Threading the Lower Looper Thread

EN
Rightmost
position
According to color
threading diagram,
Follow the 5-8 steps
(go down).
Turn the hand wheel toward you until the
lower looper reached the rightmost position.
Follow the 1-11 steps.
Guide the thread
through hole (9).
According to the
figure, the thread
from the right behind
the embedding gap
inside (B).
The thread from
front to back
through the hole
(C), be careful: The
thread must be
stuck in the groove.
Pull about 10cm of
thread through the
lower looper hole
and put it under the
presser foot.
THREADING THE LOWER LOOPER THREAD
Note: Please use the tweezers in accessories box to help threading.
Tip: For 3-thread overlock and 3-thread decorative
overcasting, the stitch will be more beautiful if not
threading through step 8.
Texi Integra 5 95