Operation - 2 - 8 CD397-Oper
June 2019 (Rev C)
Mobile Belt Loader Model 660-28 Operation
Operation Manual Section 2
2.3.2StartingInstruct ions
Procedures for maneuvering the vehicle to an aircraft are outlined below:
2.3.2.1GasEngineStartProcedure
1. Apply park brake
2. Move transmission selector to Neutral. (Starter motor will not activate unless selector is in Neutral).
3. Move ignition switch to “Start”.
4. Allow ignition switch to return to “On” upon engine start.
2.3.2.2Releaseparkbrake
The park brake is located on the drive shaft or rear axle and is activated by an Orchelin over-center lever.
With the park brake engaged, the loader will not move even when shifted into gear.
The park brake is a cable-actuated type attached to the brake shoes in the rear axle or the output shaft of
the transmission.
1. To apply park brake, pull up.
2. To release park brake, push down.
2.3.2.3Anti-RestartignitionSwitch
The Anti-Restart Ignition Switch prevents starter engagement while the engine is running.
To engage the starter:
1. The Anti-Restart Ignition Switch must be turned to the OFF position
2. And then turned to the OFF position.
WARNING:
OBSERVE ALL SAFETY PRECAUTIONS DISCUSSED IN THE SAFETY SECTION OF
THIS MANUAL.
NOTE:
Switch must be returned to “Off” (reset) before it can be moved to start again.
The starter cannot be re-engaged once the engine is running.
NOTE:
The park brake is located to the right of the driver’s seat in the driver’s compartment.
NOTE:
The starter cannot be engaged from the START position without first cycling through the
OFF position.
Property of American Airlines
To Next Page