FABRICATOR 210
June 19, 2006
9-1
SECTION 9:
PARTS LIST
9.01 Equipment Identification
All identification numbers as described in the Introduction
chapter must be furnished when ordering parts or making
inquiries. This information is usually found on the
nameplate attached to the equipment. Be sure to include
any dash numbers following the Specification or Assembly
numbers.
9.02 How To Use This Parts List
The Parts List is a combination of an illustration and a
corresponding list of parts which contains a breakdown
of the equipment into assemblies, subassemblies, and
detail parts. All parts of the equipment are listed except
for commercially available hardware, bulk items such as
wire, cable, sleeving, tubing, etc., and permanently
attached items which are soldered, riveted, or welded to
other parts. The part descriptions may be indented to show
part relationships.
To determine the part number, description, quantity, or
application of an item, simply locate the item in question
from the illustration and refer to that item number in the
corresponding Parts List.
PART NUMBER:
Fabricator 210 100047B-001
To Next Page