Remote Control Panel Features
45
The Standard Display
The Standard Display appears when the unit is
turned On and no other functions have been
selected. The box temperature appears in the
upper display and the setpoint appears in the
lower display. This display shows a box
temperature of 35.8 F and a setpoint of 35 F. The
Standard Display is the starting point used to
reach all other prompts and displays. To return to
this display from any other prompts or display,
wait 10 seconds and it will return automatically.
Figure 16: Standard Display
Changing The Setpoint
Figure 17: Changing the Setpoint
1. Press the ON key to turn the unit On.
2. Press the or ARROW keys to
select the desired setpoint.
3. Press the ENTER key to load the new
setpoint into the microprocessor. The display
will show [Lod] (abbreviation for Load) and
will display for a few seconds and then the
new setpoint will reappear in the display.
IMPORTANT: The
ENTER key must be pressed or
the setpoint WILL NOT be changed. The display
will return to the Standard Display and the
setpoint will return to the old setpoint in about
10 seconds if the
ENTER key is not pressed.
To Next Page
Loading...
Need help?
General
