Orion Benchtop pH/ISE Meter Instruction Manual
Overview of Meter Functions-410Aplus
90
Primary Key Pad Functions, Orion 410Aplus
yes Press to enter a value during calibration or setup. May
also be used to scroll through the setup menu without
changing any parameters.
no Press to cancel or to change to a parameter
before entering.
print Press to print pH value at ready prompt.
mode Press to change operating modes. The options are
MEASURE, SET UP or CALIBRATE
power Press to turn meter on or off.
Set-up menu for Orion 410Aplus
The SETUP menu is used to identify and change instrument operating
parameters. While in setup yes is used to scroll through the menu without
changing any parameters, no is used to scroll through the changes for that
parameter. To enter the setup menu press mode. After changing a setting,
press yes. Pressing no reverts the parameter to its former state (if done
before entering the new setting).
Scroll through the SETUP menu accepting or changing parameters
as desired.
To exit the SETUP menu, press mode to begin calibration or to
analyze samples.
AUTOSHUTOFF
To turn the AUTOSHUTOFF feature off, press and hold mode during
power up of the meter. After a power interruption or failure, this procedure
must be repeated.
To Next Page
Loading...
