To Next PageTo Next Page
Need help?Do you have a question about the Thermo Orion Aplus Series and is the answer not in the manual?
General| Brand | Thermo |
|---|---|
| Model | Orion Aplus Series |
| Category | Measuring Instruments |
| Language | English |
Provides guidance on navigating and utilizing the content of the instruction manual.
Procedure for initial setup, self-test, and verification for the Orion 410Aplus meter.
Procedure for initial setup, self-test, and verification for Orion 420Aplus and 710Aplus meters.
Procedure for initial setup, self-test, and verification for Orion 520Aplus and 525Aplus meters.
Procedure for initial setup, self-test, and verification for Orion 720Aplus and 920Aplus meters.
Instructions on adjusting the meter's viewing angle using the flip stand for optimal visibility.
Details the various inputs and outputs available on the rear panel of the meters.
Guides on how to properly attach BNC and pin-tip electrodes and ATC probes.
Explains the importance of buffer selection, calibration frequency, and the point-to-point scheme.
Detailed procedure for calibrating and measuring pH using the Orion 410Aplus meter.
Detailed procedure for calibrating and measuring pH using the Orion 520Aplus meter.
Detailed procedure for calibrating and measuring pH using the Orion 920Aplus meter.
Provides guidelines for concentration calibration including standards, units, and temperature.
Procedure for calibrating and measuring concentration using the Orion 710Aplus meter.
Procedure for calibrating and measuring concentration using the Orion 920Aplus meter.
Details how the meter displays temperature readings simultaneously with sample results.
Explains how to perform absolute and relative millivolt measurements on specific models.
Explains millivolt measurements for advanced models, including absolute and relative modes.
Describes how to perform redox potential measurements using specific meter models.
Details interfacing meters with computers and printers via RS232 port.
Lists remote control commands for operating meters via a PC or RS232 device.
Procedure for performing the meter's self-test to check electronic and hardware functions.
Lists and explains error codes and their probable remedies for meter issues.
Troubleshooting common meter issues like no display, autoshutoff, or erratic readings.
Explains the primary functions of each key on the Orion 410Aplus keypad.
Details how to access and navigate the setup menu for instrument parameter configuration.
Explains how to change the instrument operating mode on the meter.
Describes how to initiate a calibration sequence on the meter.
Explains how to return the meter to measure mode for sample analysis.
Function to freeze the display when the electrode signal is stable.
Allows selection of display resolution for pH and concentration measurements.
Displays the electrode slope in memory for the current operating mode.
Function to print or datalog current display data, including mode, results, and temperature.
Initiates the timer interval; an audible signal sounds upon completion.
Allows manual setting of temperature for compensation in pH and concentration modes.
Procedure for setting the current date and time on the meter.
Describes the alarm function and how to set high and low limits for measurements.
Steps to experimentally determine the electrode's isopotential point for accurate measurements.
