Regulation on the stoves ''Pelling'' is most important electronic component. It is
consisted of key controling modul set under the cover of the stove and controling unit
with display set on the front side of the stove. With controling unit it is possible to control
functions of the stove and also to check information about present state of the stove.
Due to the possibilty to work in 5 (five) different powers, regulation can satisfy needs
to increase or decrease heating by automatic adjustment of power.
If there is a need to increase power, this is registered by regulation and regulation
gives a signal to increase power by adding more pellet as well as proportional increase
of air flow in the burning basket.
When desired temperature is reached (need for heating energy is satisfied) regulation
is decreasing power ( modulates ), or when room thermostat gives signal that set
temperature is reached, stove then goes into SHUT DOWN mode (if mode STAND-
BY is ON )
To Next Page
Loading...