ThermoPro TP-17 - User-Defined Temperature Setting

Repeat the above process to set the other probe
temperature.
-10-
-11-
EN EN
Press MEAT/ST/SP to confirm and lock in the setting.
(The device will regard you've confirmed the selection if
you don't press any button for 4 seconds).
Press the MEAT/ST/SP button to enable the option to
adjust quick temperature settings.
Press ▲/HR/ or ▼/MIN/HI/LO button to select your
food type.
How to Monitor BBQ/Oven Temperature
1. You can select Probe 1 or 2 to monitor BBQ/Oven
temperature to make sure it won't exceed or go below the
set High/Low temperatures. Press Probe 1/2 to select
Probe 1 or 2 for setting. The display for the selected probe
will be flashing for a few seconds.
2 Press the MEAT/ST/SP button to enable the option to
adjust quick temperature settings.
.
3. Press the ▲/HR or▼/MIN button to choose BBQ, press
MEAT/ST/SP button to confirm the selection.
4 The HI BBQ temperature range is 140 ºF – 572 ºF and
the default setting is 250 ºF; The LO BBQ temperature
range is 32 ºF – 570 ºF and the default setting is 225 ºF.
.
5. Press and hold the MEAT/ST/SP for 3 seconds to enter
the BBQ target temperature setting.
6. While the temperature of HI BBQ is flashing, Press ▲/
HR or ▼/MIN to set your desired temperature of HI BBQ,
Press and hold the ▲/HR or▼/MIN button to make the
adjustment faster.
7 Press MEAT/ST/SP to confirm HI BBQ setting. Then the .
temperature of LO BBQ is flashing, Press ▲/HR or ▼/MIN
to set your desired temperature of LO BBQ, Press and
hold the ▲/HR or▼/MIN button to make the adjustment
faster. Note: the HI BBQ will not allow you to set the tem-
perature below the LO BBQ temperature. LO BBQ tem-
perature is always lower than the HI BBQ temperature 2ºF.
8.
temperature stops blinking.
Press MEAT/ST/SP to confirm LO BBQ setting the target
9 Press the ▲/HR button to turn on/off the alarm function..
10
temperature setting.
. Press the ▼/MIN button to toggle the display of High or Low
Press Probe 1/2 to select Probe 1 or 2 for setting. The
display for the selected probe will be flashing for a few
seconds.
table.