Thermowave TL2000 - Intended Use of the PHE

9 of 41
BA EN 12.2019 Modification 02 from 01.12.19. Copies are not subject to the change service.
2.2 Diagrams and figures
The diagrams in these operating instructions are exemplary. Many details are depicted in a simplified
manner. The binding views and dimensions of your PHE can be found in the order-related documents
[► chapter 11.3].
2.3 Intended use of the PHE
The plate heat exchanger has been specially designed and manufactured for the operating conditions
specified by you. The operating conditions have been listed on the name plate and in the technical data sheet
[► chapter 11].
Deviations from these permissible operating conditions shall result in the expiry of the warranty. This also
applies to situations in which important changes are independently made to the plate heat exchanger.
2.3.1 Personnel requirements
The PHE may only be installed, activated, operated, repaired and serviced by instructed, trained, qualified
and skilled personnel. Changes involving the PHE which have been approved in advance by the manufacturer
in writing may only be made by briefed or skilled personnel.
Training
Definition
Instructed personnel
An instructed person is a person who has been briefed and (if necessary) trained
with regard to the assigned tasks and the potential hazards associated with
inappropriate behaviour, and who has received instructions pertaining to the
required safety devices and measures.
Trained personnel
A trained person is a person who fulfils the requirements associated with an
instructed person, and who has also received training.
Qualified specialist
A specialist is a person whose training, skills, experiences and knowledge of the
applicable regulations enable him to evaluate the tasks assigned to him and
identify potential hazards. Several years’ worth of experience in the respective
work area can also be considered while evaluating the technical training.
Customer service
The customer service domain consists of service technicians who have
demonstrably been trained and authorised by thermowave for work pertaining to
the PHE.
2.3.2 Safety-relevant environmental conditions
Operate the PHE in hazard-free surroundings. An aggressive atmosphere can damage the gaskets and lead to
leaks. Consult thermowave if necessary.