Thinklogical Q Series - 2 Connecting Q-Series Kmass Modules; Fiber-Optic Cables; Transmitter Connections; Receiver Connections

Page 15
Q-Series KMASS Module Product Manual, Rev. E, March 2020 thinklogical®
2. Connecting Q-Series KMASS Modules
All physical connections to the product use industry-standard connectors. Non-supplied cables
that may be needed are commercially available. All connections are found on the rear of the
chassis.
2.1. Fiber Optic Cables
All KMASS TX modules are connected to RX modules through fiber optic cables, either
directly or through a KVM Matrix Switch to provide communication between the transmitter
and the receiver. The standard multi-mode fiber optic cables must be 50 or 62.5 microns, up to 1000
meters (3280’) long and terminated with LC-type fiber optic connectors.
T R T R
LC LC
◄Transmit◄Receive
2.2. Transmitter Connections
A TX module connects to a source CPU and peripheral device sources through provided copper
cables. The connector configurations of the Q-Series Transmitters can be viewed in detail on pg.
9-13.
2.3. Receiver Connections
An RX module connects to the destination USB and audio devices with their own standard cables. The
connector configurations of the Q-Series Receivers can be viewed in detail on pg. 9-13.
1
2 3 4
K2
K1
K1
K2
Transmitter Connections Receiver Connections