Thinky ARV-310 - Supplying Materials

4. Operation
ARV-310 4-3
4-1-3 Supplying Materials
Supply materials into the container in the procedure below:
1) Open the outer lid of the container and remove the
inner lid.
2) Put the materials into the container.
Be careful the supplied materials won’t adhere around the
container’s lip and be sure to wipe it off in case they do.
For higher mixing efficiency, put the materials as follows:
・ Put liquid and paste materials first and powder materials
afterwards.
・ Put the materials of a lighter specific gravity first and
materials of a heavier specific gravity afterwards.
・ Put the materials of a lower viscosity first and the ones of
a higher viscosity afterwards.
3) Close the inner lid and outer lid of the container tight.
・ Be sure to securely tighten the inner lid and outer lid of
the container so they may not get loose or removed
during revolution.
・ Make sure to check that the thread section of the
container is free from dirt, wear or damage.
・ Do not use any container that is damaged or with a lid
that cannot be closed securely.