・ Process your materials for a short time to check how
the temperature rises for intensive shear applied on
the materials. Then, extend the process time
eventually.
・ Do not decompress materials to below saturated
vapor pressure of water, organic solvent, etc. that
exists in the materials.
・ Do not splash and spill materials in the unit.
・ The attached special container is made of HDPE, which may be
softened or deformed at around 80℃. Process the materials in a
range of 15 to 30 seconds first to check how the temperature rises.
Set the processing time within a range where containers may not
be deformed.
When materials include low-boiling point substances, in particular,
be carefully attentive to temperature rise during mixing.
・ When performing de-aeration by vacuum decompression only,
depending on degree of viscosity of materials, air bubbles may not
burst and the material may flow over the container.
Set the processing time shorter to check the material status before
starting operation. When you expect the material overflow from the
container, immediately stop operation. When the material flows
over the container, the material is scattered around with centrifugal
force and the unit may be damaged.
・ As soon as the unit gets started, the lid gets locked and cannot be
opened until the operation is finished. To open the lid during
operation, stop the unit.
・ During vacuum decompression, vacuum forms inside of the
vacuum chamber and the lid is sealed against the chamber with air
pressure. Open the lid after the unit stops completely and the
reduced vacuum pressure in the vacuum chamber has been
released to ambient pressure.
To Next Page
Loading...