P24
MAIN MENU
7.7.2 Photo Configure
Slide Time: You can adjust the slide show interval to 1~8 seconds.
Slide Mode: You can select one of the 60 slide show effects or Random (mixed effects).
Aspect Ratio: Keep - displays the picture as its original aspect
Discard - displays the picture in full screen mode.
7.7.3 Movie configure
This subtitle function is only relevant in the Movie menu for movies which contain subtitle files in .srt
or txt format.
During playback, press SUB to select a language and confirm with OK. During playback of Movie files
you can press SUB twice to change the subtitle settings described below:
Subtitle Specific: Choose subtitle size between Small, Normal and Big.
Subtitle BG: Choose subtitle background between White, Transparent, Gray and Yellow-
Green.
Subtitle FontColour: Choose subtitle font colour between Red, Blue, Green, White and Black.
7.7.4 DVR, Timeshift and Format*
*This user manual describes the full functionality including the recording function and may not be applicable if the software
for recording via USB has not yet been installed.
7.7.4.1 Instant recording*
To directly record a programme, press the 4 button to start the recording and press 3 to quit.
During a recording it is possible to press the p/q buttons or the OK and p/q buttons to change
to another channel on the same transponder only. It is not possible to use the 0-9 buttons.
7.7.4.2 Timeshift*
If you want to use the Timeshift function you only need to press 2 in viewing mode. To playback
timeshifted content, press u or 2 again. During playback you can use the 5 6 or 2 buttons. To
quit the Timeshift mode, press 3. If you haven’t pressed 3 the Timeshift mode will be kept in the
background. If the channel is changed timeshifted content will only be accessible from the new
selected channel.
7.7.4.3 Timer recording
There are 2 ways to set a timer:
Programming a timer via the EPG
The easiest way to record an event is via the EPG. Press the EPG button to open the EPG, then tu to
select a channel. After that, press p/q to select an event. You can book a timer by pressing the OK
button. The event data will be applied and you only need to press the p/q buttons to select Mode
and tu to Record. If needed, the parameters for the timer can be changed as well. Press p/q, tu
and use 0-9 to do so. From the EPG channel list view you can open the Book list with the
button,
which allows you to open a list of all booked timers.
To Next Page
