MAIN MENU
P13
English
7.0 MAIN MENU
Press MENU in viewing mode to display the Main Menu. All important settings and features
of your receiver can be operated from the Main Menu. It consists of the following sub-menus:
Installation, Update & Info, Conditional Access, Channel Manager and Timer.
Use
tu to select a sub-menu and pq to choose an option. Press OK to advance to the
chosen submenu.
7.1 Installation
This menu allows you to change satellite settings and to search for channels. Further you can
adjust important settings for your receiver. It consists of the following sub-menus: Antenna
Setup, Channel Search, System Settings, Parental Lock and Factory Reset. Choose the
desired sub menu with
pq and press OK to advance.
7.1.1 Antenna Setup
Use this menu to change or add the settings for an already installed or new satellite and to
configure its parameters. In the Type line you can adjust if you’re using a DiSEqC switch or not
by using
tu to change. If your setup differs you can adjust DiSEqC OFF or use default setting
DiSEqC 1.0.
Is DiSEqC OFF used you will only be able to setup one satellite. Press OK to open the settings
for this connection.
For the usage with DiSEqC 1.0 you can enter the same parameters for up to 4 satellite
positions.
Edit LNB
Satellite: Press OK to open the list of available satellites and chose the
desired one with
pq or PG+/-.
LNB Type: Choose the desired LNB Type via the
tu buttons if you are not
using a universal LNB.
LNB Low Freq.: This shows the value for the appropriate LNB Type used and you
can only adjust for “Normal” LNB.
LNB High Freq.: This shows the value for the appropriate LNB Type used and you
can only adjust for “Normal” LNB.
22KHz Tone: This setting for AUTO should not be changed, only in case it is
necessary for your LNB type.
LNB Power: Here you can change the LNB power via
tu in case it is
necessary.
Transponder: Press OK to open the list of available transponders for the chosen
satellite, in order to check your reception or align the antenna.
Use the RED button SAT Edit to rename the chosen satellite and use the GREEN button Add
TP to add a new transponder to this satellites database.
7.1.1.1 SAT Edit
This submenu allows to rename the chosen satellite and also to change its orbital position. Use
pq to choose Satellite or Position.
Satellite: Press OK to open the keyboard and use the 0 ~ 9 buttons, like
common from your mobile, to enter a new name (max. 9 signs).
Once the desired name is entered, use
pq to choose OK in
order to rename or choose Cancel to discard.
Position: Use 0 ~ 9 to enter the orbital position. If necessary, you can use
OK and
pq to change the hemisphere from E to W respectively
vice versa.
By using the
pq buttons you can select OK to change or Cancel to discard.
To Next Page
Loading...
