YOUR RECEIVER
P3
English
WARNING: Indicates warning information.
NOTE: Indicates any other additional important or helpful information.
MENU Represents a button on the remote control or the receiver.
(Bold Characters)
Move to Represents a menu item within a screen.
(Italic Characters)
1.4 Accessories
User Manual
1 Remote control unit
2x Batteries (AAA type)
1x Adaptor 12 Volt DC, 2 Ampere
1x infrared extender
WARNING: The batteries should not be recharged, disassembled, electrically short-circuited, be mixed
or used with other types of batteries.
If rechargeable accumulators instead of batteries are going to be used, we recommend using
(e.g. NiMH) types with low self-discharge to ensure long time operation of remote control.
1.5 Usage of external USB devices
It is recommended to use USB 2.0 storage devices. If your device is not compatible to USB
2.0 specifications, recording, timeshift and playback with your receiver might not work properly.
If you are going to use external USB HDD (Hard Disk Drive) please consider that it might be the
case that the power specifications exceed the supported output of your receiver (5V/1A). If so,
please connect your USB HDD to an according external power adapter.
THOMSON cannot guarantee compatibility with all types of USB storage devices.
It is advised not to store important information on USB storage devices used with the receiver.
Always make backups of data on your USB storage device before using it with this receiver.
THOMSON will not take responsibility for any loss of information or circumstances caused by
loss of information.
Please ensure that either the USB device is already formatted to FAT/FAT32, or format the USB
device via your receiver, refer to chapter 7.4.5 HDD Manager for details.
2.0 YOUR RECEIVER
2.1 DEFAULT PIN-CODE: 0000
2.2 Front Panel
Fig.1
1. Standby/ON button Turns the receiver ON or into Standby
2. P-/P+ buttons Switches to the previous/next programme
3. V-/V+ buttons Reduces or increases the volume level
4. IR Sensor Receives the RCU commands
5. White LED Display Displays channel number, time, videotext page or PVR modes
6. Red Indication LED Indicates that receiver is currently in power saving mode
7. Smart card slot To insert your Irdeto Smart card
NOTE: 5 min after switching the receiver to standby it enters the deep sleep mode. Within this time
the receiver is able to start up quickly. Starting up from deep sleep takes approx. 1 min.
To Next Page
Loading...
