MAIN MENU
P13
English
LNB Power Here you can change the LNB power with tu if necessary.
Transponder Press OK to open the list of available transponders for the chosen satellite, in
order to check your reception or align the antenna.
Press the RED button SAT Edit to rename the chosen satellite and press the GREEN button Add TP to add a
new transponder to this satellites database.
7.1.1.1 SAT Edit
This submenu allows renaming of the chosen satellite and changing of its orbital position. Use pq to
choose Satellite or Position.
Satellite: Press OK to open the keyboard and enter a new name with the 0 ~ 9 buttons
(max. 9 signs). When you have entered the preferred name, press pq to choose
OK in order to rename or choose Cancel to discard.
Position: Use 0 ~ 9 to enter the orbital position. If necessary, you can use OK and pq to
change the hemisphere from E to W or vice versa.
By pressing the pq buttons you can select OK to change or Cancel to discard.
7.1.1.2 New TP
This submenu allows adding one or more transponders to the database of the selected satellite. This
enables you to check the signal or adjust the antenna for this satellite. Further you can perform a NIT
Search on the new satellite when you have added the appropriate transponder. The full editing functions
are available in the Channel Search menu. Here use the pq buttons to navigate.
Frequency: Enter a frequency with the 0 ~ 9 buttons.
Symbol rate: Enter the required symbol rate with the 0 ~ 9 buttons.
Polarization: Here the polarization can be changed with tu.
By pressing the pq buttons you can select OK to change or Cancel to discard.
After all settings are adjusted according to your system requirements, press
to leave this menu. A
message will inform about the changes, use the pq buttons to select Yes to save or No to discard and
confirm with OK. The receiver will return to the selection screen and you can continue.
If you want to delete a satellite press the GREEN button. If you want to delete all satellites that have been
setup press the YELLOW button to do so. When all settings have been made, press to leave this menu.
7.1.2 Channel Search
Use this menu to perform an automatic, network or transponder channel search or to search on all
satellites that have been setup. Use pq to highlight an item and tu to change settings. Below the
settings you can find the search method selection.
Antenna Here you can change the antenna port with tu if you have configured more
than one satellite.
Satellite Here you will see the satellite that is assigned to the antenna in above, you can
only see the satellite(s) which has/have been setup in the Antenna Setup menu
before.
Transponder list By pressing tu you can change between the transponders referring to the
selected satellite, you can also press OK to list up and select with pq or P+/P.
Afterwards press OK to choose. Press RED to Edit TP, with GREEN you can Delete
TP and with BLUE you can enter data for a new transponder Add TP.
For the further procedure in Edit TP and Add TP see chapter 7.1.1.2 Add TP. In Delete TP a message will be
displayed to apply your changes, use pq to select Yes to apply or No to cancel and confirm with OK.
Scan Mode Here you can decide which channels you want to scan for: Either scan all channels
FTA & $, for Free-To Air only FTA or use CA to scan for scrambled channels only.
Channel Type TV & Radio will scan for TV and radio channels, TV for TV channels only and Radio
for radio channels only.
To Next Page
