P12
MAIN MENU
NOTE: Timeshift only works correctly when a fast USB storage device such as a USB2.0 HDD is
connected to the receiver. Distorted picture and/or audio during Timeshift indicate a too
slow USB device speed. THOMSON cannot guarantee for USB devices used. Especially when
Timeshift is activated at channels with high data rate (High quality SD/HD), THOMSON
cannot guarantee an accurate playback of the Timeshift file.
WARNING: The broadcasting rights of encrypted channels may be limited by the provider and fast
forward/rewind may not be possible or the Timeshift function may be limited.
6.10 Playback of recording
If you have made recordings you can access the HDD Manager directly from viewing mode by pressing u.
Select the recorded event with pq and start the playback in full sceen mode with OK. Alternatively you
can press 1 to start playback in preview mode. Further options are displayed in the HDD Manager. For a
detailed description of the menu please refer to chapter 7.4.4 HDD Manager.
WARNING: For encrypted channels broadcasting rights may be limited by the seller, which is why some
channels are restricted during playback to fast forward/rewind, or possibly limited in another
way. When the Maturity Rating is activated for a certain programme, you must enter the
corresponding PIN code MATURITY RATING MASTER PIN: 0000 to be able to record this
programme.
7.0 MAIN MENU
Press MENU in viewing mode to display the Main Menu. All important settings and features of your
receiver can be operated from the Main Menu. It consists of the following sub-menus: Installation, Update &
Info, Conditional Access, Channel Manager and Timer.
Use tu to select a sub-menu and pq to choose an option. Press OK to advance to the chosen
submenu.
7.1 Installation
This menu allows you to change satellite settings and to search for channels. Further you can adjust
important settings for your receiver. It consists of the following sub-menus: Antenna Setup, Channel Search,
System Settings, Parental Lock and Factory Reset. Choose a sub menu with pq and press OK to advance.
7.1.1 Antenna Setup
Use this menu to change or add the settings for an already installed or new satellite and to configure its
parameters. In the Type line you can adjust if you’re using a DiSEqC switch or not by using tu to change.
If your setup differs you can adjust DiSEqC OFF or use the default setting DiSEqC 1.0.
If you use DiSEqC OFF you will only be able to setup one satellite. Press q and then OK to open the
settings for this connection.
For the usage with DiSEqC 1.0 you can enter the same parameters for up to 4 satellite positions.
Edit LNB
Satellite Press OK to open the list of available satellites and chose the preferred satellite
with pq or P+/P and confirm by pressing OK.
LNB Type Choose LNB Type with tu if you are not using a universal LNB.
LNB Low Freq. This shows the value for the appropriate LNB Type used and you can only adjust
for “Normal” LNB.
LNB High Freq. This shows the value for the appropriate LNB Type used and you can only adjust
for “Normal” LNB.
22KHz Tone This setting for AUTO should not be changed, only if is necessary for your LNB
type.
To Next Page
