P4
YOUR RECEIVER
The user manual available on our website www . thomsonstb . net provides complete instructions for
installing and using this receiver. The symbols serve as follows.
WARNING Indicates warning information.
NOTE Indicates any other additional important or helpful information.
MENU Represents a button on the remote control or the receiver. (Bold characters)
Move to Represents a menu item within a screen. (Italic characters)
1.4 Accessories
• 1x Quick Installation Guide
• 1x remote control unit
• 2x batteries (AAA type)
• 1x adaptor 12 Volt DC, 2 Ampere
• 1x infrared extender
WARNING: The batteries should not be recharged, disassembled, electrically short-circuited, be mixed or
used with other types of batteries.
If rechargeable accumulators instead of batteries are going to be used, we recommend using (e.g. NiMH)
types with low self-discharge to ensure long time operation of remote control.
1.5 Usage of external USB devices
• It is recommended to use USB 2.0 storage devices. If your device is not compatible to USB 2.0
specifications, recording, playback, Timeshift and multimedia functions of your receiver might not work
properly.
• If you are going to use external USB HDD (Hard Disk Drive) please consider that specifications may exceed
the supported output of your receiver (5V/1A). If so, please connect your USB HDD to an according
external power adapter.
• THOMSON cannot guarantee compatibility with all types of USB storage devices.
• It is advised not to store important information on USB storage devices used with the receiver. Always
make backups of data on your USB storage device before using it with this receiver. THOMSON will not
take responsibility for any loss of information or circumstances caused by loss of information.
• Please ensure that either the USB device is already formatted to FAT/FAT32, or format the USB device
via your receiver, refer to chapter 7.4.4 HDD Manager of the user manual available on our website
www . thomsonstb . net for details.
• THOMSON cannot guarantee the playback of all multimedia files although extensions are listed, as it
depends on file size, codec, bit rate and resolution.
2.0 YOUR RECEIVER
2.1 DEFAULT PIN-CODE: 0000
2.2 Front Panel
Fig.1
1. Standby/ON button
Turns the receiver ON or into Standby
2. IR Sensor Receives the RCU commands
3. LED Display Displays channel number, time, videotext page or
PVR modes
4. Smart card slot To insert your Irdeto Smart card
5. Indicator LED GREEN indicates that the receiver is currently ON, GREEN and RED blinking
indicates that the receiver is preparing to enter deep sleep, RED indicates that the
receiver is currently in deep sleep mode.
To Next Page
Loading...
