MAIN MENU
P15
English
OSD transparency: Defines the transparency of menus and banner. Press tu to choose between
25%, 50%, 75% and fifty-fifty.
When all settings have been made, press to leave the System Settings menu. When returning to viewing
mode the receiver informs with a message that it saves your settings.
7.1.3.1 HDMI
In this submenu you can set following parameters:
TV Ratio 16:9 or 4:3, depending on the kind of your TV set.
Conversion Letterbox, PanScan or Combined, to choose the preferred picture format.
Video Output Only selectable for Scart
Resolution 576p, 720p, 1080i or 1080p, to adjust the optimum resolution your TV set supports.
HDCP ON or OFF, please see the note below.
NOTE: HDCP (High Definition Content Protection) is set to ON per default as nowadays all TV sets
with an HDMI connector support HDCP. If you have problems with the HDMI connection you
can use the Scart setting to deactivate HDCP, which will allow watching via HDMI without
problems. Consider that movies which are broadcasted with an extra content protection
might not be shown when HDCP is set to OFF.
NOTE: If you configure an HDMI resolution which isn’t supported by your TV, there is no problem
because if you press no button the receiver will switch to the last used resolution after ~ 10
sec automatically. However, if you can see the displayed message, then confirm the selected
resolution by pressing OK.
7.1.3.2 SCART
In this submenu you can set following parameters:
TV Ratio 16:9 or 4:3, depending on the kind of your TV set.
Conversion Letterbox, PanScan or Combined, to choose the preferred picture format.
Video Output RGB or CVBS, depending on what your TV set supports, but for Scart we
recommend RGB.
Resolution Only selectable for HDMI
HDCP ON or OFF, please see the note above.
After all settings are adjusted following to your preference, choose Save with pq and press OK. The
receiver returns to the menu.
7.1.3.3 Select Audio Language
In this submenu you can set up to four preferred audio languages:
First Language Either use OK for a list with all available languages or use tu to select one.
Second Language Either use OK for a list with all available languages or use tu to select select one.
Third Language Either use OK for a list with all available languages or use tu to select select one.
Fourth Language Either use OK for a list with all available languages or use tu to select select one.
The receiver will automatically switch to the preferred audio language whenever available. If the first
language is not available it will switch to the second language. Should both the first and the second
language be unavailable it switches to the third language and so on.
After all settings are adjusted following to your preference, choose Save with pq and press OK. The
receiver returns to the menu.
7.1.3.4 Select Subtitle Language
In this submenu you can set up if you want to display DVB subtitles and select your language accordingly:
Subtitle Display Use tu to select ON or OFF depending on DVB subtitle display being preferred
or not.
To Next Page
