THOMSON THT712 - Connection; Connecting to a Terrestrial Antenna; Connecting to TV with HDMI Cable; Connecting to TV with SCART Cable

7
English
NOTE: Managing the receiver will be limited or not possible if there are
obstacles between the remote control sensor (at the front panel of
the receiver) and the remote control. Direct sunlight or very bright
light can reduce or disturb the reception of the remote control
signals.
3.0 CONNECTION
3.1 Connecting to a terrestrial antenna
Fig. 6
To receive broadcast signals, your terrestrial indoor or outdoor antenna must be connected to
the ANT IN connector on the back of the receiver. Use a proper shielded antenna cable and
suitable connectors.
NOTE: If the signals at your location are too weak to receive proper
signals with an indoor antenna, we recommend using an outdoor
antenna which can be pointed towards the transmission tower.
Ask your local dealer for more information. If you are using an
active antenna with built-in antenna amplier, switch the antenna
power to ON in the menu Manual Search.
3.2 Connecting to TV with HDMI cable
Fig. 6
The TV set shall be connected to the receiver using a good quality HDMI cable. This connection
gives the highest possible picture quality.
3.3 Connecting to TV with SCART cable
Fig. 6
Your receiver is also equipped with a SCART connector; alternatively, the TV set can be
connected to the receiver using a good quality SCART cable.
3.4 Connecting a USB storage device
Fig. 6
This port can be used for USB storage devices such as USB pen drives or HDD with a maximum
peak current of 500 mA. It is recommended to use USB 2.0 storage devices (or higher) for
playback of video les or HD movies.