5
English
2.0 YOUR RECEIVER
2.1 DEFAULT PIN: 0000
2.2 Front Panel
Fig. 1
1. IR Sensor Receives commands from the remote control
2. LED Display Shows channel number and time in standby
3. Mode Indicator LED RED indicates that the receiver is in STANDBY mode.
4. Standby/ON button Switches the receiver ON or into Standby
5. USB To connect your USB storage device.
2.3 Rear Panel
Fig. 2
1. ANT IN To connect to your antenna for reception of broadcast
signals.
2. ETHERNET To connect to your Ethernet cable (RJ-45) for RSS feeds
and weather forecasts
3. S/PDIF Coaxial To connect your receiver to a digital home cinema set,
AV receiver or digital audio amplier
4. HDMI To connect your receiver with your TV-set using an HDMI
cable.
5. TV SCART To connect your receiver with your TV-set using a SCART
cable.
6. Power cord To connect to the main power (100 - 240 V AC ~ 50/60
Hz)
7. Power switch To switch the receiver on or o.
2.4 Remote control
Fig. 3
1. q Switches the receiver On/Standby.
2. ! Mutes all audio outputs of the receiver
3. FAV Opens the favourite group selection.
4. LIST Call the current channel list.
5. AUDIO Opens the audio* language selection
6. 9 One step back in menu or back to previous channel.
7. COLOUR BUTTONS In dierent menus for specic functions
8. Opens the current channel information; 2x opens
the current event information and 3x the next event
information.*
9. EPG Opens the EPG* (Electronic Programme Guide) in TV
mode.
To Next Page
Loading...
