THOMSON THT712 - Main Menu; Installation of Channels

13
English
6.7.4 Playback
After a recording has been made you will nd a new folder Records created on your external
USB storage device. By pressing u in viewing mode you can access this folder directly. Inside
the Records menu the following functions are supported:
pq To select a record event.
OK Starts playback in preview and again in full screen mode.
3 Stops playback
RED Opens the option menu to select and deselect for deleting a record le(s).
This menu item opens only if you have selected rst a le by using pq.
Marks a recording for deletion. When all recordings you want to
delete are marked, select Deleted Selected press OK. A message will
appear to conrm deleting. By pressing OK again the recordings will
be permanently deleted from your external USB storage device. Select
Cancel if you don’t want to delete them or select once more OK to
denitely delete.
7.0 MAIN MENU
The main menu gives you access to Installation, Channels, Settings, Multimedia and Network
functions. To access the main menu, press MENU in viewing mode. Throughout the main menu,
9 can be used to get back to the previous screen and  to quit.
7.1 Installation of channels
Use t u to select the main menu item Installation.
Use pq to highlight the submenu of choice and press OK to select.
7.1.1 Manual Search
This menu allows you to search for channels at a specic Frequency or Channel number.
Use pq to select Scan mode, and select between Free which will only install Free-to-Air
channels or All. This means that channels that are Free-to-Air or scrambled will be searched
and stored.
Use pq to select Channel No and select the channel number of the frequency you’d like to
search. Press OK to open a list to make selection faster.
The next option Modulation is to select between Only DVB-T or DVB-T+T2 modulation type.
When in doubt, use the DVB-T+T2 setting.
If you use an active antenna (with built-in amplier), then switch the Antenna Power to On. If
you use a passive antenna (without built-in amplier), then select O.
Highlight Search and press OK to start scanning. New found channels will be added to the
channel list.