12
6.7 Record, Timeshift and Format
To use these functions you must connect a USB memory device to the USB port at the rear
panel. For best performance, especially of HD content, we advice to use Hard Disk drives
USB 2.0 or higher. These must be formatted in FAT32 format, otherwise Record and Timeshift
function will not work.
6.7.1 Instant recording
To immediately record a programme, press 4 to start the recording and press 3 to quit. During
a recording it is possible to press pq, or OK and pq to change to another channel on the
same transponder (frequency) only. Also it is possible to use the 0-9 buttons.
6.7.2 Timeshift
If you want to use the Timeshift function you only need to press 2 in viewing mode. To resume
timeshifted content, press u or 2 again. During the playback you can use the 5 6 or 2
buttons. To stop the Timeshift mode, press 3 and it will jump to the actual time of the live
signal. The function will still be running in the background and as long you do not switch to
another channel it is possible to jump again to the beginning by pressing 2 again. Also, with
t u it is possible to jump in time during Timeshift modes. Default is set to 20 seconds. Press
the GREEN Jump Set button to change the jump time.
If the channel is changed timeshifted content will only be accessible from the newly selected
channel.
NOTE: To switch o the Timeshift function completely you need to
change the Timeshift status to disable in the Record setup menu.
6.7.3 Timer recording
There are 2 ways to set a timer:
Programming a record timer via the EPG
The easiest way to record an event is via the EPG. Press the EPG button to open the EPG, then
use pq to select a channel. After that, press t u and use pq to select an event. You can
book a record timer by pressing 4. If you press 4 again on this event, the timer will be disabled.
The set time of timer is xed and cannot be modied.
Programming a record timer via the Timer menu
If you want to programme a record timer via the timer menu, press the BLUE button from EPG
to open it. Also you can select it via the MENU button on the remote control in viewing mode,
option Timer in the menu Settings. This way you are free to programme start and stop time. For
further details about this menu, please refer to chapter 7.3.6 Timer in the user manual.
To Next Page
Loading...
