21
English
7.4.3 Storage Device Setup
This option shows relevant information about the connected USB device. In this menu you can
also format your USB storage device and safely remove.
Select Storage Device Setup in the Multimedia menu and press OK to enter.
Now you will see all details as free and used space sizes and used le system.
Press the RED Safely Remove button and press OK to safely disconnect the USB device. The
receiver will display a message indicating that you can now safely remove your storage device
from the receiver. Press the BLUE Format USB Device button to format the connected USB
device.
Please, enter your PIN code to access this menu and press OK to start formatting.
Press to leave this menu.
NOTE: After performing the Safely Remove function, the USB device is
no longer accessible by your receiver. To gain access to you’re the
storage device again, re-insert it or switch the receiver to standby
and on again.
WARNING: Formatting will permanently delete ALL data stored on the
connected device. Please make a backup copy of all data you wish
to keep before entering the Format menu. STRONG cannot be
held responsible for loss of data from USB devices used with this
receiver.
NOTE: It is possible to use USB storage devices already formatted in
NTFS.
* Playback of les cannot be guaranteed although extensions are listed, as it depends on codec, data bit rate and
resolution used (all MPEG codec formats are supported).
7.5 Network
The Network menu consists of the following submenus: RSS, Weather and IP Settings. Connect
rst the CAT5E (or better) cable into RJ-45 ETHERNET port of your receiver and the other end
into your router.
Before you can use the Internet functions you need to check the setup of the Internet
connection in the IP Settings menu. Use pq to highlight the menu of choice and press OK to
enter. Press to quit.
7.5.1 IP Settings
This menu allows you to setup or check the Internet connection. The default selection is DHCP
set to On. Normally the setup is done automatically by this. To test if the Internet connection
works, select the item SET and press OK. If successful, a pop-up message box will show up and
you can start using it. If not successful, then check your cable or router. Alternatively set DHCP
To Next Page
Loading...
