20
Pictures:
pq Enter the folder with picture les. Use pq to select a picture. If the
format is supported it shows the picture in the small picture-in-picture
screen. Press OK to watch it in full screen mode.
RED Option: Before the playback of a picture in full screen, you can setup a slideshow/
diashow. Press the RED button Option to enter the sub option menu
Slide change Time. Select time of the slide show or switch this function
o. After you select a time, press OK and show starts to play. Press the
button to stop.
7.4.2 Record Setup
This menu is only accessible if you connect a USB storage device. Here you can setup Timeshift
and recording.
The following settings are available:
Timeshift Status: Choose between Enable to activate the Timeshift function or
Disable to switch it o. This function will also automatically be
set to Enable if you press 2 on the remote and have USB device
connected.
Timeshift Step: Select the time size step in minutes and seconds which you like
to make by using t u during navigation in Timeshift modes.
Use the 0~9 buttons to enter the time.
Timeshift Duration: Select the maximal time (size) which is reserved for the time
shift function. Use the 0~9 buttons to enter the duration.
Record Duration: Select the default maximum time for recordings that can be
started with the 4 button. Use the 0~9 buttons to enter the
duration.
Start Record earlier: If you want to start the recording, set under timer from
EPG some minutes earlier than the time obtained from the
programme guide.
End Record later: If you want to stop the recording, set under timer from EPG
some minutes later as time obtained from the programme
guide.
REC Icon: If you start a recording, an icon will be shown in the left upper
corner of your TV screen with the text “REC”. Default is set to
On. Select 5 Seconds or 10 Seconds to let the icon disappear after
the selected time.